| Step | | Procedure & Parts & Tools |
| 1 |
|
Either have water in tank, or adjust water sensor to show orange and green LED's on a dry hose.
|
| 2 |
|
Access Power Board and bypass seat switch
|
| 3 |
|
Disable drive by removing Black (negative) Drive Cable from Power Board. Use 4mm Allen Wrench
| Wrench-Allen metric 4.0mm |
|
|
| 4 |
|
locate pump connector on board
|
| 5 |
|
Insert needle probes into Red and Blue wires
| Volt meter (True RMS capable) |
&Width=100)
|
|
| 6 |
|
Activate brush and solution system to full settings
|
| 7 |
|
Press pedal down...pump should show 24+V on full setting - gradually decreasing with lower settings. Approx 15-16V at Setting 1.
|